10.1.7 Quickstart Guide

This section provides a brief example of ADS111x communications. See subsequent sections of this data sheet for more detailed explanations. Hardware for this design includes: one ADS111x configured with an I²C address of 1001000; a microcontroller with an I²C interface; discrete components such as resistors, capacitors, and serial connectors; and a 2 V to 5 V power supply. Figure 43 shows the basic hardware configuration.

The ADS111x communicate with the master (microcontroller) through an I²C interface. The master provides a clock signal on the SCL pin and data are transferred using the SDA pin. The ADS111x never drive the SCL pin. For information on programming and debugging the microcontroller being used, see the device-specific product data sheet.

The first byte sent by the master is the ADS111x address, followed by the R/W bit that instructs the ADS111x to listen for a subsequent byte. The second byte is the Address Pointer register byte. The third and fourth bytes sent from the master are written to the register indicated in register address pointer bits P[1:0]. See Figure 30 and Figure 31 for read and write operation timing diagrams, respectively. All read and write transactions with the ADS111x must be preceded by a START condition, and followed by a STOP condition.

For example, to write to the configuration register to set the ADS111x to continuous-conversion mode and then read the conversion result, send the following bytes in this order:

1. Write to Config register:
   • First byte: 0b10010000 (first 7-bit I²C address followed by a low R/W bit)
   • Second byte: 0b00000001 (points to Config register)
   • Third byte: 0b10000100 (MSB of the Config register to be written)
   • Fourth byte: 0b10000011 (LSB of the Config register to be written)
2. Write to Address Pointer register:
   • First byte: 0b10010000 (first 7-bit I²C address followed by a low R/W bit)
   • Second byte: 0b00000000 (points to Conversion register)
3. Read Conversion register:
   • First byte: 0b10010001 (first 7-bit I²C address followed by a high R/W bit)
   • Second byte: the ADS111x response with the MSB of the Conversion register
   • Third byte: the ADS111x response with the LSB of the Conversion register

Figure 43. Basic Hardware Configuration