6 Pin Configuration and Functions

Figure 6-1 DLH Package 10-Pin (top view)

Table 6-1 Pin Functions

Pin		I/O^⁽¹⁾	Description
Name	NO.	I/O^⁽¹⁾	Description
IN	10	P	DC input power supply. IN is connected to the external DC supply. Bypass IN to GND with at least 1 uF of capacitance using a ceramic capacitor.
SYS	1	P	Regulated system output. Connect at least 10uF ceramic capacitor (at least 1uF of ceramic capacitance with DC bias de-rating) from SYS to GND as close to the SYS and GND pins as possible.
BAT	2	P	Battery connection. Connect to the positive terminal of the battery. Bypass BAT to GND with at least 1uF of ceramic capacitance.
GND	5	-	Ground connection. Connect to the ground plane of the circuit.
ILIM/VSET	7	I/O	Input current limit and battery regulation voltage program input. Refer to ILIM/VSET Control
ISET	8	I/O	Fast charge current program input. We recommend an RC for small charge current values. Prefer to work only with one resistor.
STAT1	9	O	Open drain status output. Can be pulled up to 1- 20kohm resistor. Typical pull up voltage = 1.8V, Max pull up voltage = 5V. Refer to the Status Pins section for more details.
TS/MR	6	I/O	Manual reset input/ NTC thermistor pin. TS/MR is a general purpose input that must be held low for greater than t_LPRESS to go into Factory mode. TS/MR may be driven by a momentary push-button or a MOS switch. The TS/MR pin can also have an NTC thermistor connected on to it. Refer to External NTC Montitoring Section (TS) section.
CE	4	I	Charge enable active-low input. Connect CE to a high logic level to disable charging. Connect to a low logic level to enable charging.
STAT2	3	O	Open drain status output. Can be pulled up to 1- 20kohm resistor. Typical pull up voltage = 1.8V, Max pull up voltage = 5V. Refer to the Status Pins section for more details.

(1) I = Input, O = Output, I/O = Input or Output, G = Ground, P = Power.