The following reference designs should be followed closely when implementing designs using the CC1352P device.
Special attention must be paid to RF component placement, decoupling capacitors and DCDC regulator
components, as well as ground connections for all of these.
The
high-power PA requires a specific RF matching for optimum current efficiency at 10 dBm output power (2.4 GHz). Refer to the application note Optimizing the SimpleLink CC1352P for Coin Cell Operation at 10 dBm Output
Power for details.
Integrated matched filter-balun devices can be used both at sub-1 GHz frequencies and at 2.4 GHz for the low-power RF
outputs. Refer to the "Integrated Passive Component" section in
CC13xx/CC26xx Hardware Configuration and PCB Design Considerations for further information.
CC1352PEM-XD7793-XD24-PA9093 Design Files
The CC1352PEM-XD7793-XD24-PA9093 reference design provides schematic, layout and production files for the characterization board used for
deriving the performance number found in this document. This board includes tuning for 915 MHz on the high-power PA output.
CC1352PEM-XD7793-XD24-PA24 Design Files
The CC1352PEM-XD7793-XD24-PA24 reference design provides schematic, layout and production files for the characterization board used for
deriving the performance number found in this document. This board includes tuning for 2.4 GHz on the high-power PA output.
LAUNCHXL-CC1352P1 Design Files
Detailed schematics and layouts for the multi-band CC1352P LaunchPad evaluation board featuring 868/915 MHz RF matching on the 20 dBm PA
output and up to 5 dBm TX power at 2.4 GHz.
LAUNCHXL-CC1352P-2 Design Files
Detailed schematics and layouts for the multi-band CC1352P LaunchPad evaluation board featuring 2.4 GHz RF matching on the 20 dBm PA output
and up to 14 dBm TX power at 868/915 MHz.
LAUNCHXL-CC1352P-4 Design Files
Detailed schematics and layouts for the multi-band CC1352P LaunchPad evaluation board featuring 2.4 GHz RF matching optimized for 10 dBm
operation on the 20 dBm PA output and up to 13 dBm TX power at 433 MHz.
Sub-1 GHz and 2.4 GHz Antenna Kit for LaunchPad™
Development Kit and SensorTag
The antenna kit allows real-life testing to identify the optimal antenna for your application. The antenna kit includes 16 antennas for
frequencies from 169 MHz to 2.4 GHz, including:
- PCB antennas
- Helical antennas
- Chip antennas
- Dual-band antennas for 868 MHz and 915 MHz combined with 2.4 GHz
The antenna kit includes a JSC cable to connect to the Wireless MCU LaunchPad development kits and SensorTags.