There are no specific layout guidelines for the DMD as typically DMD is connected using a board to board connector to a flex cable. Flex cable provides the interface of data and Ctrl signals between the DLPC3479 controller and the DLP4710LC DMD. For detailed layout guidelines refer to the layout design files. Some layout guideline for the flex cable interface with DMD are:

• Match lengths for the LS_WDATA and LS_CLK signals.
• Minimize vias, layer changes, and turns for the HS bus signals. Refer Figure 10-1.
• Minimum of two 220-nF decoupling capacitor close to VBIAS. Capacitor C3 and C10 in Figure 10-1.
• Minimum of two 220-nF decoupling capacitor close to VRST. Capacitor C1 and C9 in Figure 10-1.
• Minimum of two 220-nF decoupling capacitor close to VOFS. Capacitor C2 and C8 in Figure 10-1.
• Minimum of four 220-nF decoupling capacitor close to VDDI and VDD. Capacitor C4, C5, C6 and C7 in Figure 10-1.