6.6.1 EMIF
The EMIF module provides connectivity between DDR memory types and manages data bus read/write accesses between external memory and device subsystems which have master access to the L3_MAIN interconnect and DMA capability.
The EMIF module has the following capabilities:
- Supports JEDEC standard-compliant DDR2-SDRAM and DDR3/DDR3L-SDRAM memory types
- 2-GiB SDRAM address range over one chip-select.
- Supports SDRAM devices with one, two, four or eight internal banks
- Data bus widths:
- 128-bit L3_MAIN (system) interconnect data bus width
- 32-bit SDRAM data bus width
- 16-bit SDRAM data bus width used in narrow mode
- Supported CAS latencies:
- DDR3: 5, 6, 7, 8, 9, 10 and 11
- DDR2: 2, 3, 4, 5, 6 and 7
- Supports 256-, 512-, 1024-, and 2048-word page sizes
- Supported burst length: 8
- Supports sequential burst type
- SDRAM auto initialization from reset or configuration change
- Supports self refresh and power-down modes for low power
- Partial array self-refresh mode for low power when DDR3 is used
- Output impedance (ZQ) calibration for DDR3
- Supports on-die termination (ODT) for DDR2 and DDR3
- Supports prioritized refresh
- Programmable SDRAM refresh rate and backlog counter
- Programmable SDRAM timing parameters
- Write and read leveling/calibration and data eye training for DDR3
- ECC on the SDRAM data bus:
- 7-bit ECC over 32-bit data
- 6-bit ECC over 16-bit data when narrow mode is used
- 1-bit error correction and 2-bit error detection
- Programmable address ranges to define ECC protected region
- ECC calculated and stored on all writes to ECC protected address region
- ECC verified on all reads from ECC protected address region
- Statistics for 1-bit ECC and 2-bit ECC errors
- The total width of the ECC DDR data bus is 8 bits
The EMIF module does not support:
- Burst chop for DDR3
- Interleave burst type
- Auto precharge because of better Bank Interleaving performance
- OCD calibration for DDR2
- CAS Read Latency of 2 and CAS Write Latency of 1 for DDR2
- DLL disabling from EMIF side
For more information, see section DDR External Memory Interface (EMIF) in chapter Memory Subsystem of the device TRM.