米6体育平台手机版

ZHCSFB0D June 2016 – November 2023 DRV2510-Q1

PRODUCTION DATA

6.5 Electrical Characteristics

T_A = 25°C, AVCC = VDD = 12 V, R_L = 5 Ω (unless otherwise noted)

PARAMETER		TEST CONDITIONS	MIN	TYP	MAX	UNIT
\| V_OS \|	Output offset voltage (measured differentially)	V_I = 0 V, Gain = 20 dB	–25		25	mV
I_VDD	Quiescent supply current	No load or filter		16		mA
I_VDD(SD)	Quiescent supply current in shutdown mode	No load or filter		5	20	µA
I_VDD(STDBY)	Quiescent supply current in standby mode	No load or filter		7		mA
r_DS(on)	Drain-source on-state resistance, measured pin to pin	T_J = 25°C		180		mΩ
G	Gain	P_(o) = 1 W	19	20	21	dB
			25	26	27	dB
			31	32	33	dB
			35	36	37	dB
V_REG	Regulator voltage		6.4	6.9	7.4	V
V_O	Output voltage (measured differentially)			20		V
PSRR	Power supply ripple rejection	VDD = 12 V + 1 Vrms at 1 kHz		75		dB
V_ICMIN	Input common-mode min			0.3		V
V_ICMAX	Input common-mode max			4.4
CMRR	Common-mode rejection ratio	f = 1 kHz, 100 mVrms referenced to GND. Gain = 20 dB		63		dB
f_OSC	Oscillator frequency (with PWM duty cycle < 96%)			400		kHz
f_OSC	Oscillator frequency (with PWM duty cycle < 96%)			500		kHz
	Output resistance in shutdown			10		MΩ
	Resistance to detect a short from OUT pin(s) to VDD or GND				200	Ω
	Open-circuit detection threshold		75	95	120	Ω
	Short-circuit detection threshold		0.9	1.2	1.5	Ω
	Power-on threshold			4.1		V
	Thermal trip point			150		°C
	Thermal hysteresis			15		°C
	Over-current trip point			3.5		A
	Over-voltage trip point			21		V
	Over-voltage hysteresis			0.6		V
	Under-voltage trip point			4		V
	Under-voltage hysteresis			0.25		V
INTZ Report
	INTZ pin output voltage for logic-level high (open-drain logic output)	External 47-kΩ pullup resistor to 3.3 V	2.4			V
	INTZ pin output voltage for logic-level low (open-drain logic output)	External 47-kΩ pullup resistor to 3.3 V			0.5	V