8.2.1 Design Requirements

As with any high-speed design, there are many factors which influence the overall performance. Below are a list of critical areas for consideration and study during design.

• Use 100-Ω impedance traces. Generally these are very loosely coupled to ease routing length differences.
• Place AC-coupling capacitors near to the receiver end of each channel segment to minimize reflections.
• The maximum body size for AC-coupling capacitors is 0402.
• Back-drill connector vias and signal vias to minimize stub length.
• Use Reference plane vias to ensure a low inductance path for the return current.

8.2.2 Detailed Design Procedure

The DS100KR800 is designed to be placed at an offset location with respect to the overall channel attenuation. In order to optimize performance, the repeater requires tuning to extend the reach of the cable or trace length while also recovering a solid eye opening. To tune the repeater, the settings mentioned in Table 2 and Table 3 are recommended as a default starting point for most applications. Once these settings are configured, additional tuning of the EQ and, to a lesser extent, VOD may be required to optimize the repeater performance for each specific application environment.

Examples of the repeater performance as a generic high-speed datapath repeater are shown in the performance curves in the Application Curves.

8.2.3 Application Curves

Figure 10. TL = 20 inch 4–mil FR4 Trace,
DS100KR800 Settings: EQ[1:0] = R, R = 15'h, DEM[1:0] = Float, Float

Figure 12. TL1 = 20 inch 4–mil FR4 Trace, TL2 = 15 inch 4–mil FR4 Trace,
DS100KR800 Settings: EQ[1:0] = R, R = 15'h, DEM[1:0] = Float, Float

Figure 11. TL = 30 inch 4–mil FR4 Trace,
DS100KR800 Settings: EQ[1:0] = Float, R = 1F'h, DEM[1:0] = Float, Float

Figure 13. TL1 = 30 inch 4–mil FR4 Trace, TL2 = 15 Inch 4–mil FR4 Trace,
DS100KR800 Settings: EQ[1:0] = Float, R = 1F'h, DEM[1:0] = Float, Float