9 Revision History
Changes from Revision A (November 2000) to Revision B (April 2024)
- 更新了整个文档中的表格、图和交叉参考的格式Go
- 通篇删除了有关 INA117AM 和 INA117SM 型号的信息Go
- 在说明 及引脚配置和功能 部分中将引脚 8 从“Comp”更改为“NC”Go
- 向说明 部分添加了封装信息 表Go
- Added Pin Functions tableGo
- Added ESD Ratings tableGo
- Added single supply specification to Recommended Operating Conditions
Go
- Added specified temperature range to Recommended Operating Conditions
Go
- Added VREF = 0V, VCM = VS/2, and G = 1 to "unless otherwise noted" conditions in Electrical Characteristics and Typical Characteristics for clarityGo
- Changed parameter from "Offset voltage vs Temperature" to "Offset voltage drift" in Electrical Characteristics
Go
- Added test condition of "TA = –40°C to +85°C" for "Offset voltage drift" in Electrical Characteristics
Go
- Changed parameter from "Offset Voltage vs Power Supply" to "Power-supply rejection ratio" in Electrical Characteristics
Go
- Added test condition of "TA = –40°C to +85°C" for "CMRR" in Electrical Characteristics
Go
- Changed "Common-mode input impedance" typical value from 400kΩ to 200kΩ in Electrical Characteristics
Go
- Added test condition "TA = –40°C to +85°C" for "Gain error vs temperature" in Electrical Characteristics and renamed to "Gain error drift" for clarityGo
- Changed "Gain nonlinearity" typical value from 0.0002% to 0.0005% in Electrical Characteristics
Go
- Added test condition "Continuous to VS/2" to Short-circuit current specification in Electrical Characteristics for clarityGo
- Change minimum Slew rate from 2V/µs to 1.7V/µs in Electrical Characteristics
Go
- Deleted redundant voltage range, operating temperature range, and specification temperature range specifications from Electrical Characteristics
Go
- Deleted Reducing Differential Gain application circuit figure Go
- Added Documentation Support and Related Documentation
sectionsGo