over operating free-air temperature range (unless otherwise noted)(1)
|
|
MIN |
MAX |
UNIT |
| VS
|
Supply voltage |
Single supply, VS = (+VS) |
|
40 |
V |
| Dual supply, VS = (+VS) – (–VS) |
|
±20 |
| VIN
|
Signal input pins |
Common Mode (2)
|
(–VS) – 0.5 |
(+VS) + 0.5 |
V |
| Differential (3)
|
|
±0.5 |
| VREF
|
VREF pin |
(–VS) – 0.5 |
(+VS) + 0.5
|
V |
| VFL
|
Filter input pins +FL, –FL |
(–VS) – 0.5 |
(+VS) + 0.5
|
V |
| VO
|
Signal output pins maximum voltage |
(–VS) – 0.5 |
(+VS) + 0.5 |
V |
| IO
|
Signal output pins maximum current |
–50 |
50 |
mA |
| IS
|
Output short-circuit(4)
|
–50 |
50 |
mA |
| TA
|
Operating temperature (5)
|
|
125 |
°C |
| TJ
|
Junction temperature (5)
|
|
175 |
°C |
| Tstg
|
Storage temperature |
|
150 |
°C |
(1) Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only, which do not imply functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating Conditions. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that swing more than 0.5 V beyond the supply rails must be current-limited to 10 mA or less.
(3) Input terminals are anti-parallel diode-clamped to each other. Input signals that cause differential voltages of swing more than ± 0.5 V must be current-limited to 10 mA or less.
(4) Short-circuit to VS / 2.
(5) As a result of the quiescent current, a supply voltage and load-dependent self-heating of the device must be considered.