ZHCSAS0L January 2005 – December 2014 LP38691 , LP38691-Q1 , LP38693 , LP38693-Q1
PRODUCTION DATA.
LP3869x 低压降 CMOS 线性稳压器具有严密的输出容差(典型值 2%)和极低压降(在负载电流为 500A、V输出= 5V 时为 250mV),并且采用超低等效串联电阻 (ESR) 陶瓷输出电容器,可提供出色的交流性能。
此稳压器采用低热阻的 WSON、SOT-223 以及 TO-252 封装,即使在周围温度较高的环境下也可实现满电流运行。
PMOS 功率晶体管的使用意味着无需直流基极驱动电流对其进行偏置,因此无论负载电流、输入电压或者运行温度为何,接地引脚电流均可保持在 100µA 以下。
压降:500mA(5V 输出电压典型值)条件下为 250mV(典型值)
接地引脚电流:满负载时为 55µA(典型值)
精密输出电压:精度为 2% (25°C)
器件型号 | 封装 | 封装尺寸(标称值) |
---|---|---|
LP38691 | TO-252 (3) | 6.58mm x 6.10mm |
WSON (6) | 3.00mm × 3.00mm | |
LP38693 | SOT-223 (5) | 6.50mm x 3.56mm |
WSON (6) | 3.00mm × 3.00mm | |
LP38691-Q1 | WSON (6) | 3.00mm × 3.00mm |
LP38693-Q1 |
PIN | I/O | DESCRIPTION | ||||
---|---|---|---|---|---|---|
NAME | TO-252 | WSON | SOT-223 | |||
IN | 3 | 1, 6 | 1, 6 | 4 | I | This is the input supply voltage to the regulator. For WSON devices, both VIN pins must be tied together for full current operation (250mA maximum per pin). |
GND | TAB | 2 | 2 | 5 | — | Circuit ground for the regulator. For the PFM and SOT-223 packages this is thermally connected to the die and functions as a heat sink when the soldered down to a large copper plane. |
SNS | — | 5 | 5 | — | I | WSON Only - Output sense pin allows remote sensing at the load which will eliminate the error in output voltage due to voltage drops caused by the resistance in the traces between the regulator and the load. This pin must be tied to VOUT. |
EN | — | — | 3 | 1 | I | The enable pin allows the part to be turned ON and OFF by pulling this pin high or low. |
OUT | 1 | 4 | 4 | 3 | O | Regulated output voltage |
DAP | — | √ | √ | — | — | WSON Only - The DAP (Exposed Pad) functions as a thermal connection when soldered to a copper plane. See WSON Mounting section for more information. |