Apply an external clock synchronization signal to the LV5144 to synchronize switching in both frequency and phase. Requirements for the external clock SYNC signal are:

• Clock frequency range: 100 kHz to 1 MHz
• Clock frequency: –20% to +50% of the free-running frequency set by R_RT
• Clock maximum voltage amplitude: 13 V
• Clock minimum pulse width: 50 ns

Figure 8-5 Typical 400-kHz SYNCIN and SW Voltage Waveforms

Figure 8-5 shows a clock signal at 400 kHz and the corresponding SW node waveform (V_IN = 48 V, V_OUT = 5 V, free-running frequency = 280 kHz). The SW voltage waveform is synchronized with respect to the rising edge of SYNCIN. The rising edge of the SW voltage is phase delayed relative to SYNCIN by approximately 100 ns.