米6体育平台手机版

ZHCSOU8B August 2021 – February 2022 MCT8316A

PRODUCTION DATA

封装选项

机械数据 (封装 | 引脚)

RGF|40
- MPQF173F

散热焊盘机械数据 (封装 | 引脚)

RGF|40
- QFND672

订购信息

8.4.1.3 Fault Reset (CLR_FLT)

In the case of latched faults, the device goes into a partial shutdown state to help protect the power MOSFETs and system. When the fault condition clears, the device can go to the operating state again by setting the CLR_FLT to 1b.

Table 8-19 Conditions to Enter or Exit Sleep or Standby Modes

SPEED COMMAND MODE	ENTER STANDBY CONDITION	ENTER SLEEP CONDITION	EXIT FROM STANDBY CONDITION	EXIT FROM SLEEP CONDITION
Analog	SPEED pin voltage < V_{EN_SB} for t_{DET_SB_ANA}	SPEED pin voltage < V_{EN_SL} for t_{DET_SL_ANA}	SPEED pin voltage > V_{EX_SB} for t_{DET_ANA}	SPEED pin voltage > V_{EX_SL} for t_{DET_ANA}
PWM/ Frequency	SPEED pin low (V < V_{DIG_IL}) for t_{EN_SB_PWM}/ t_{EN_SB_FREQ}	SPEED pin low (V < V_{DIG_IL}) for t_{DET_SL_PWM}/ t_{DET_SL_FREQ}	SPEED pin high (V > V_{DIG_IH}) for t_{DET_PWM}	SPEED pin high (V > V_{DIG_IH}) for t_{DET_PWM}
I²C	SPEED_CTRL is programmed as 0.	SPEED pin voltage < V_{EN_SL} for t > SLEEP_TIME	SPEED_CTRL is programmed as non-zero.	SPEED pin voltage > V_{EX_SL} for t_{DET_ANA}