米6体育平台手机版

ZHCSDO6B May 2015 – September 2020 MSP430FG6425 , MSP430FG6426 , MSP430FG6625 , MSP430FG6626

PRODUCTION DATA

封装选项

机械数据 (封装 | 引脚)

PZ|100
- MTQF013A

散热焊盘机械数据 (封装 | 引脚)

PZ|100
- QFND428

订购信息

8.8.4.1 Wake-up Times From Low-Power Modes and Reset

over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)

PARAMETER		TEST CONDITIONS		TYP	MAX	UNIT
t_WAKE-UP-FAST	Wake-up time from LPM2, LPM3, or LPM4 to active mode⁽¹⁾	PMMCOREV = SVSMLRRL = n (where n = 0, 1, 2, or 3), SVSLFP = 1	f_MCLK ≥ 4 MHz	3	6.5	µs
t_WAKE-UP-FAST	Wake-up time from LPM2, LPM3, or LPM4 to active mode⁽¹⁾		1 MHz < f_MCLK < 4 MHz	4	8.0	µs
t_WAKE-UP-SLOW	Wake-up time from LPM2, LPM3, or LPM4 to active mode⁽²⁾⁽³⁾	PMMCOREV = SVSMLRRL = n (where n = 0, 1, 2, or 3), SVSLFP = 0		150	165	µs
t_WAKE-UP-LPM5	Wake-up time from LPM3.5 or LPM4.5 to active mode⁽⁴⁾			2	3	ms
t_{WAKE-UP-RESET}	Wake-up time from RST or BOR event to active mode⁽⁴⁾			2	3	ms

(1) This value represents the time from the wake-up event to the first active edge of MCLK. The wake-up time depends on the performance mode of the low-side supervisor (SVS_L) and low-side monitor (SVM_L). t_WAKE-UP-FAST is possible with SVS_L and SVM_L in full performance mode or disabled. For specific register settings, see the Low-Side SVS and SVM Control and Performance Mode Selection section in the Power Management Module and Supply Voltage Supervisor chapter of the MSP430F5xx and MSP430F6xx Family User's Guide.

(2) This value represents the time from the wake-up event to the first active edge of MCLK. The wake-up time depends on the performance mode of the low-side supervisor (SVS_L) and low-side monitor (SVM_L). t_WAKE-UP-SLOW is set with SVS_L and SVM_L in normal mode (low current mode). For specific register settings, see the Low-Side SVS and SVM Control and Performance Mode Selection section in the Power Management Module and Supply Voltage Supervisor chapter of the MSP430F5xx and MSP430F6xx Family User's Guide.

(3) The wake-up times from LPM0 and LPM1 to AM are not specified. They are proportional to MCLK cycle time but are not affected by the performance mode settings as for LPM2, LPM3, and LPM4.

(4) This value represents the time from the wake-up event to the reset vector execution.