This section describes the necessary steps to configure the PCM1822 for this specific application. The following steps provide a sequence of steps that must be executed in the time between powering the device up and reading data from the device or transitioning from one mode to another mode of operation.

1. Apply power to the device:
   1. Power-up the IOVDD and AVDD power supplies
   2. The device now goes into low-power mode
2. Configure the pins for correct configuration:
   1. Connect the MSZ, FMT0, MD0, and MD1 pin voltages for the desired configuration
   2. Apply FSYNC and BCLK with the desired output sample rates and the BCLK to FSYNC ratio

      See the Section 8.3.3 section for supported sample rates and the BCLK to FSYNC ratio

   3. The device recording data are now sent to the host processor via the audio serial data bus
3. Stop the clocks to stop recording of data at any time