at TA = 25°C, AVDD = 3.3 V, IOVDD = 3.3
V, fIN = 1-kHz sinusoidal signal, fS = 48 kHz, 32-bit audio
data, BCLK = 256 × fS, TDM slave mode, PLL on, DRE_LVL = –36 dB,
channel gain = 0 dB, and linear phase decimation filter (unless otherwise noted);
all performance measurements are done with a 20-kHz, low-pass filter, and an
A-weighted filter
Figure 7-1 Differential Input: THD+N vs Input Amplitude With DRE Enabled
Figure 7-3 Differential Input: DR vs Input Frequency With DRE Enabled
Figure 7-5 Differential Input: THD+N vs Input Frequency With a –1-dBr
Input
Figure 7-7 Power-Supply Rejection Ratio vs Ripple Frequency With a
100-mVPP Amplitude
Figure 7-9 Differential Input: FFT With Idle Input and DRE
Disabled
Figure 7-11 Differential Input: FFT With a –60-dBr Input and
DRE Disabled
Figure 7-13 Single-Ended Input: THD+N vs Input Amplitude With DRE
Disabled
Figure 7-15 Single-Ended Input: DR vs Input Frequency With DRE
Disabled
Figure 7-17 Single-ended Input: Frequency Response With a –12-dBr
Input
Figure 7-19 Single-ended Input: FFT With Idle Input and DRE
Disabled
Figure 7-21 Single-ended Input: FFT With a –60-dBr Input and
DRE Disabled
Figure 7-2 Differential Input: THD+N vs Input Amplitude With DRE
Disabled
Figure 7-4 Differential Input: DR vs Input Frequency With DRE
Disabled
Figure 7-6 Differential Input: Frequency Response With a –12-dBr
Input
Figure 7-8 Differential Input: FFT With Idle Input and DRE
Enabled
Figure 7-10 Differential Input: FFT With a –60-dBr Input and
DRE Enabled
Figure 7-12 Differential Input: FFT With a –1-dBr Input
Figure 7-14 Single-ended Input: DR vs Input Frequency With DRE Enabled
Figure 7-16 Single-Ended Input: THD+N vs Input Frequency With a –1-dBr
Input
Figure 7-18 Single-ended Input: FFT With Idle Input and DRE
Enabled
Figure 7-20 Single-ended Input: FFT With a –60-dBr Input and
DRE Enabled
Figure 7-22 Single-ended Input: FFT With a –1-dBr Input