SN6507-Q1 is an open-loop transformer driver without load regulation capability. The output voltage may vary over a wide range load current. Therefore, if a high-accuracy, load independent supply is required, the implementation of a low dropout regulator (LDO) on the output side is strongly advised.

The minimum requirements for a suitable low dropout regulator are:

• Its current drive capability should slightly exceed the specified load current of the application to prevent the LDO from dropping out of regulation. Therefore, for a load current of 200 mA, choose a 200 mA to 300 mA LDO. While regulators with higher drive capabilities are acceptable, they also usually possess higher dropout voltages that will reduce overall converter efficiency.
• The internal dropout voltage, V_DO, at the specified load current should be as low as possible to maintain efficiency. For a low-cost 300 mA LDO, a V_DO of 600 mV at 300 mA is common. Be aware; however, that this lower value is usually specified at room temperature and can increase by a factor of 2 over temperature, which in turn will raise the required minimum input voltage.
• The required minimum input voltage preventing the regulator from dropping out of line regulation is given with:
  Equation 5. V_I-min = V_DO-max + V_O-max

  This means in order to determine V_I for worst-case condition, the user must take the maximum values for V_DO and V_O specified in the LDO data sheet for rated output current (that is, 200 mA) and add them together. Also specify that the output voltage of the push-pull rectifier at the specified load current is equal or higher than V_I-min. If it is not, the LDO will lose line-regulation and any variations at the input passes straight through to the output. Hence, below V_I-min the output voltage follows the input and the regulator behaves like a simple conductor.

• The maximum regulator input voltage must be higher than the rectifier output under no-load. Under this condition there is no secondary current reflected back to the primary, thus making the voltage drop across R_DS-on negligible and allowing the entire converter input voltage to drop across the primary. At this point, the secondary reaches its maximum voltage of
  Equation 6. V_S-max = V_IN-max × N

with V_IN-max as the maximum converter input voltage and n as the transformer turns ratio. Thus to prevent the LDO from damage the maximum regulator input voltage must be higher than V_S-max. Table 9-2 lists the maximum secondary voltages for various turns ratios commonly applied in push-pull converters.