The device has many supported features and flexible options that can be used in the system to seamlessly connect multiple TAC5412-Q1 devices by sharing a single common I²C or SPI control bus and an audio serial interface bus. This architecture enables multiple applications to be applied to a system that require a microphone or speaker array for beam-forming operation, audio conferencing, noise cancellation, and so forth. Figure 6-14 shows a diagram of multiple TAC5412-Q1 devices in a configuration where the control and audio data buses are shared.

The TAC5412-Q1 consists of the following features to enable seamless connection and interaction of multiple devices using a shared bus:

• Supports up to four pin-programmable I²C target addresses
• I²C broadcast simultaneously writes to (or triggers) all TAC5412-Q1 devices
• Supports up to 32 configuration input/output channel slots for the audio serial interface
• Tri-state feature (with enable and disable) for the unused audio data slots of the device
• Supports a bus-holder feature (with enable and disable) to keep the last driven value on the audio bus
• The GPIOx, GPI1 or GPO1 pin can be configured as a secondary input/output data lane or as a secondary audio serial interface
• The GPIOx, GPI1 or GPO1 pin can be used in a daisy-chain configuration of multiple TAC5412-Q1 devices
• Supports one BCLK cycle data latching timing to relax the timing requirement for the high-speed interface
• Programmable controller and target options for both primary and secondary audio serial interface
• Ability to synchronize the multiple devices for the simultaneous sampling requirement across devices

See the Multiple TAC5x1x Devices With a Shared TDM and I²C/SPI Bus application report for further details.