7 Parameter Measurement Information

Figure 7-1 Test System: Operating Voltage Range with RX and TX Access: Parameters 9, 10

Figure 7-2 RX Response: Operating Voltage Range

Figure 7-3 LIN Bus Input Signal

Figure 7-4 LIN Receiver Test with RX access Parameters 17, 18, 19, 20

Figure 7-5 V_{SUP_NON_OP} Parameters 11

Figure 7-6 Test Circuit for I_{BUS_LIM} at Dominant State (Driver on) Parameters 12

Figure 7-7 Test Circuit for I_{BUS_PAS_dom}; TXD = Recessive State V_BUS = 0 V, Parameters 13

Figure 7-8 Test Circuit for I_{BUS_PAS_rec} Param 14

Figure 7-9 Test Circuit for I_{BUS_NO_GND} Loss of GND

Figure 7-10 Test Circuit for I_{BUS_NO_BAT} Loss of Battery

Figure 7-11 Test Circuit Slope Control and Duty Cycle Parameters 27, 28, 29, 30

Figure 7-12 Definition of Bus Timing Parameters

Figure 7-13 Propagation Delay Test Circuit; Parameters 31, 32

Figure 7-14 Propagation Delay

Figure 7-15 Mode Transitions

Figure 7-16 Wakeup Through EN

Figure 7-17 Wakeup through LIN

Figure 7-18 Test Circuit for AC Characteristics