ZHCSH12A October 2017 – December 2018 TLV2313-Q1 , TLV313-Q1
PRODUCTION DATA.
| 参数 | 测试条件 | 最小值 | 典型值 | 最大值 | 单位 | ||
|---|---|---|---|---|---|---|---|
| 失调电压 | |||||||
| VOS | 输入失调电压 | 0.75 | 3 | mV | |||
| dVOS/dT | 输入偏移电压与温度间的关系 | TA = –40°C 至 125°C | 2 | µV/°C | |||
| PSRR | 电源抑制比 | 74 | 90 | dB | |||
| 输入电压范围 | |||||||
| VCM | 共模电压范围 | 无相位反向，轨到轨输入 | (V-)-0.2 | (V+)+0.2 | V | ||
| CMRR | 共模抑制比 | (V–) – 0.2V < VCM < (V+) – 1.3V | 85 | dB | |||
| VCM = –0.2V 至 5.7V | 64 | 80 | |||||
| 输入偏置电流 | |||||||
| IB | 输入偏置电流 | ±1 | pA | ||||
| IOS | 输入失调电流 | ±1 | pA | ||||
| 噪声 | |||||||
| 输入电压噪声（峰峰值） | f=0.1Hz 至 10Hz | 6 | µVPP | ||||
| en | 输入电压噪声密度 | f=10kHz | 22 | nV/√Hz | |||
| f = 1kHz | 26 | ||||||
| in | 输入电流噪声密度 | f=1kHz | 5 | fA/√Hz | |||
| 输入电容 | |||||||
| CIN | 差分电压 | 1 | pF | ||||
| 共模 | 5 | ||||||
| 开环增益 | |||||||
| AOL | 开环电压增益 | 0.05V < VO < (V+) – 0.05V
RL = 100kΩ |
104 | dB | |||
| 0.3V < VO < (V+) – 0.3V
RL = 2kΩ |
100 | 110 | |||||
| 相位裕度 | VS = 5V，G = +1 | 65 | ° | ||||
| 频率响应 | |||||||
| GBW | 增益带宽积 | VS = 5V，CL = 10pF | 1 | MHz | |||
| SR | 压摆率 | VS = 5V，G = +1 | 0.5 | V/µs | |||
| tS | 建立时间 | 精度达到 0.01%，VS=5V，2V 阶跃，G = +1 | 6 | µs | |||
| 过载恢复时间 | VS = 5V，VIN × 增益 > VS | 3 | µs | ||||
| 输出 | |||||||
| VO | 相对于电源轨的电压输出摆幅 | RL = 100kΩ(2) | 5 | 20 | mV | ||
| RL = 2kΩ(2) | 75 | 100 | |||||
| ISC | 短路电流 | ±15 | mA | ||||
| RO | 开环输出阻抗 | 2300 | Ω | ||||
| 电源 | |||||||
| VS | 额定电压范围 | 1.8 (±0.9) | 5.5 (±2.75) | V | |||
| IQ | 每个放大器的静态电流 | TA = –40°C 至 125°C，VS = 5V，IO = 0mA | 65 | 90 | µA | ||
| 加电时间 | VS=0V 至 5V，达到 90% IQ水平 | 10 | µs | ||||