4 修订历史记录

Changes from H Revision (March 2016) to I Revision

• Added acknowledgement information to the SMBus Alert Function section Go
• Added register comparison information to the Limit Registers sectionGo
• Removed sentence from the TMP432 Status Register section: Clearing the Status Register bits does not clear the state of the ALERT pin; an SMBus alert response address command must be used to clear the ALERT pin. Go
• Added new ALERT pin information to the Configuration Register 1 sectionGo
• Changed extended measurement range from: (–55°C to 150°C) to: (–64°C to 191°C) Go
• Added Conversion Rate Timing Diagram Go
• Split the η table column into η = 1.008 and η = 1.000 in the η-Factor Range tableGo

Changes from G Revision (December 2015) to H Revision

• Changed row 1B in Table 4Go
• Changed 7th paragraph of TMP432 Status Register section Go
• Changed Open Status Register sectionGo
• Added last sentence to High Limit Status Register sectionGo
• Added last sentence to Low Limit Status Register section Go

Changes from F Revision (August 2013) to G Revision

• 添加了 ESD 额定值表、特性 说明部分、器件功能模式、应用和实施部分、电源相关建议部分、布局部分、器件和文档支持部分以及机械、封装和可订购信息部分Go
• Changed the Timing Requirements table with new I²C data. Updated affected values throughout the data sheet Go

Changes from E Revision (December 2012) to F Revision

• Added five new register descriptionsGo

Changes from D Revision (November 2012) to E Revision

• 通篇将 MSOP-10 更改为 VSSOP-10Go

Changes from C Revision (February 2011) to D Revision

• 通篇将 MSOP-8 更改为 VSSOP-8Go

Changes from B Revision (April 2010) to C Revision

• Revised Figure 14Go
• Updated Figure 15Go
• Changed Figure 16Go
• Revised Figure 17Go
• Updated Serial Bus Address section for TMP431C, TMP431D device versionsGo
• Added footnote (3) to TMP431 Register MapGo
• Revised information about power-on reset value of THERM limit registers in Limit Registers sectionGo

Changes from A Revision (November 2009) to B Revision

• Corrected Equation 7Go

Changes from * Revision (September 2009) to A Revision

• Changed 通篇更改了 TMP432 的器件状态Go
• Corrected bit D6 value in Configuration Register 1 in TMP431 Register MapGo