The TPS1210x-Q1 feature adjustable short-circuit protection. The threshold and response time can be adjusted using R_SCP resistor and C_TMR capacitor respectively. The device senses the voltage across CS+ and CS– pins.

These pins can be connected across an external high and low side current sense resistor (R_SNS) or across the FET drain and source terminals for FET RDSON sensing as shown in Figure 9-5, Figure 9-6 and Figure 9-7 respectively.

Figure 9-5 TPS12100-Q1 Application Circuit With External Sense Resistor RSNS based High Side Current Sensing

Figure 9-7 TPS12100-Q1 Application Circuit with External Sense Resistor RSNS based Low Side Current Sensing

Figure 9-6 TPS12100-Q1 Application Circuit With MOSFET RDSON based Current Sensing

Set the short-circuit detection threshold using an external R_SCP resistor across ISCP and GND pins. Use Equation 5 to calculate the required R_SCP value:

Refer to Equation 9 in Application Limitations section for update in equation in final revision of IC.

Where,

R_SNS is the current sense resistor value or the FET R_DSON value.

I_SC is the desired short-circuit current level.

The short-circuit protection response is fastest with no C_TMR cap connected across TMR and GND pins.

With the device powered ON and EN/UVLO, INP1 pulled high, During Q1 turn-ON, first VGS of external FET Q1 (G1 gate drive) is sensed by monitoring the voltage across G1PD to SRC. Once G1PD to SRC voltage raises above V_{(G1_GOOD)} threshold which ensures that the external FET is enhanced, then the SCP comparator output is monitored. If the sensed voltage across CS+ and CS– exceeds the short-circuit set point (V_(SCP)), G1PD pulls low to SRC and FLT asserts low. Subsequent events can be set either to be auto-retry or latch off as described in following sections.