ZHCSQN1 October 2023 TPS1210-Q1
ADVANCE INFORMATION
| PARAMETER | TEST CONDITIONS | MIN | TYP | MAX | UNIT | |
|---|---|---|---|---|---|---|
| SUPPLY VOLTAGE | ||||||
| VS | Operating input voltage | 3.5 | 40 | V | ||
| I(Q) | Total system quiescent current, I(GND) | V(EN/UVLO) = 2 V | 35 | µA | ||
| I(SHDN) | SHDN current, I(GND) | V(EN/UVLO) = 0 V, V(SRC) = 0 V | 1.5 | µA | ||
| ENABLE, UNDERVOLTAGE LOCKOUT (EN/UVLO), SHORT CIRCUIT COMPARATOR TEST (SCP_TEST) INPUT | ||||||
| V(UVLOR) | UVLO threshold voltage, rising | 1.24 | V | |||
| V(UVLOF) | UVLO threshold voltage, falling | 1.14 | V | |||
| V(ENR) | Enable threshold voltage for low Iq shutdown, rising | 1.02 | V | |||
| V(ENF) | Enable threshold voltage for low Iq shutdown, falling | 0.3 | V | |||
| V(SCP_TEST) | SCP test mode rising threshold | 1.02 | V | |||
| V(SCP_TEST) | SCP test mode rising threshold | 0.3 | V | |||
| I(EN/UVLO) | Enable input leakage current | V(EN/UVLO) = 12 V | 180 | nA | ||
| CHARGE PUMP (BST–SRC) | ||||||
| V(BST – SRC_ON) | Charge Pump turn on voltage | V(EN/UVLO) = 2 V | 10 | V | ||
| V(BST – SRC_OFF) | Charge Pump turn off voltage | V(EN/UVLO) = 2 V | 11.8 | V | ||
| V(BST_UVLOR) | V(BST – SRC) UVLO voltage threshold, rising | V(EN/UVLO) = 2 V | 9.5 | V | ||
| V(BST_UVLOF) | V(BST – SRC) UVLO voltage threshold, falling | V(EN/UVLO) = 2 V | 7.2 | V | ||
| I(SRC) | SRC pin leakage current | V(EN/UVLO) = 2 V, V(INP1) = V(INP2) = 0 V | 1 | µA | ||
| GATE DRIVER OUTPUTS (G1PU, G1PD, G2) | ||||||
| I(G1PU), I(G2_src) | Peak Source Current | 1.69 | A | |||
| I(G1PD), I(G2_snk) | Peak Sink Current | 2 | A | |||
| V(G1_GOOD) | VGS Good Threshold for G1 Gate Drive |
7.5 | V | |||
| SHORT CIRCUIT PROTECTION (ISCP) | ||||||
| V(SCP) | SCP threshold | R(ISCP) = 145 kΩ | 240 | 300 | 360 | mV |
| R(ISCP) = 32.5 kΩ | 75 | mV | ||||
| R(ISCP) = 15 kΩ | 40 | mV | ||||
| DELAY TIMER (TMR) | ||||||
| I(TMR_SRC_CB) | TMR source current | 80 | µA | |||
| I(TMR_SRC_FLT) | TMR source current | 2.2 | µA | |||
| I(TMR_SNK) | TMR sink current | 2.5 | µA | |||
| V(TMR_SC) | 1.1 | V | ||||
| V(TMR_LOW) | 0.2 | V | ||||
| N(A-R Count) | 32 | |||||
| INPUT CONTROLS (INP1, INP2), CURRENT SENSE SELECT (CS_SEL) AND FAULT FLAG (FLT) | ||||||
| R(FLT) | FLT Pull-down resistance | 70 | Ω | |||
| V(INP1_H) , V(INP2_H) | TPS12100-Q1 Only | 2 | V | |||
| V(INP1_L) , V(INP2_L) | TPS12100-Q1 Only | 0.8 | V | |||
| V(CS_SEL_H) | CS_SEL threshold for low side sensing | 2 | V | |||
| V(CS_SEL_L) | CS_SEL threshold for high side sensing | 0.8 | V | |||