ZHCSJU9E January 2007 – June 2019 TPS40077
PRODUCTION DATA.
PARAMETER | TEST CONDITIONS | MIN | TYP | MAX | UNIT | |
---|---|---|---|---|---|---|
VVDD | Input voltage range, VIN | 4.5 | 28 | V | ||
IVDD | Quiescent current | Output drivers not switching | 2.5 | 3.5 | mA | |
VLVBP | Output voltage | TA = TJ = 25°C | 3.9 | 4.2 | 4.5 | V |
OSCILLATOR/RAMP GENERATOR | ||||||
fOSC | Accuracy | 450 | 500 | 550 | kHz | |
VRAMP | PWM ramp voltage(1) | VPEAK – VVAL | 2 | V | ||
VRT | RT voltage | 2.23 | 2.4 | 2.58 | V | |
tON | Minimum output pulse time(1) | CHDRV = 0 nF | 150 | ns | ||
Maximum duty cycle | VFB = 0 V, 100 kHz ≤ fSW ≤ 500 kHz | 84% | 93% | |||
VFB = 0 V, fSW = 1 MHz | 76% | 93% | ||||
VKFF | Feed-forward voltage | 0.35 | 0.4 | 0.45 | V | |
IKFF | Feed-forward current operating range(1) | 20 | 1100 | μA | ||
SOFT START | ||||||
ISS | Charge current | 7 | 12 | 17 | μA | |
tDSCH | Discharge time | CSS = 3.9 nF | 25 | 75 | μs | |
tSS | Soft-start time | CSS = 3.9 nF, VSS rising from 0.7 V to 1.6 V | 210 | 290 | 500 | μs |
VSSSD | Turnon threshold | 310 | 365 | 420 | mV | |
Shutdown threshold | 225 | 275 | 325 | |||
VSSSDH | Shutdown threshold hysteresis | 35 | 150 | mV | ||
VDBP | Output voltage | VDD > 10 V | 7 | 8 | 9 | V |
VDD = 4.5 V, IOUT = 25 mA | 4 | 4.3 | ||||
ERROR AMPLIFIER | ||||||
VFB | Feedback regulation voltage total variation | TJ = 25°C | 0.698 | 0.7 | 0.704 | V |
0°C ≤ TJ ≤ 85°C | 0.69 | 0.7 | 0.707 | |||
–40°C ≤ TJ ≤ 85°C | 0.69 | 0.7 | 0.715 | |||
VSS | Soft-start offset from VSS(1) | Offset from VSS to error amplifier | 1 | V | ||
GBW | Gain bandwidth(1) | 5 | 10 | MHz | ||
AVOL | Open-loop gain | 50 | dB | |||
ISRC | Output source current | 2.5 | 4.5 | mA | ||
ISINK | Output sink current | 2.5 | 6 | mA | ||
IBIAS | Input bias current | VFB = 0.7 V | –250 | 0 | nA | |
SHORT-CIRCUIT CURRENT PROTECTION | ||||||
IILIM | Current sink into current limit | 80 | 105 | 125 | μA | |
VILIM(ofst) | Current limit offset voltage (VSW – VILIM) | VILIM = 11.5 V, VVDD = 12 V | –75 | –50 | –30 | mV |
tHSC | Minimum HDRV pulse duration | During short circuit | 135 | 225 | ns | |
Propagation delay to output(1) | 50 | ns | ||||
tBLANK | Blanking time(1) | 50 | ns | |||
tOFF | Off time during a fault (SS cycle times) | 7 | Cycles | |||
VSW | Switching level to end precondition
(VVDD – VSW)(1) |
2 | V | |||
tPC | Precondition time(1) | 100 | ns | |||
VILIM | Current limit precondition voltage threshold(1) | 6.8 | V | |||
OUTPUT DRIVERS | ||||||
tHFALL | High-side driver fall time (HDRV – SW)(1) | CHDRV = 2200 pF | 36 | ns | ||
tHRISE | High-side driver rise time (HDRV – SW)(1) | 48 | ns | |||
tHFALL | High-side driver fall time (HDRV – SW)(1) | CHDRV = 2200 pF, VVDD = 4.5 V,
0.2 V ≤ VSS ≤ 4 V |
72 | ns | ||
tHRISE | High-side driver rise time (HDRV – SW)(1) | 96 | ns | |||
tLFALL | Low-side driver fall time(1) | CLDRV = 2200 pF | 24 | ns | ||
tLRISE | Low-side driver rise time(1) | 48 | ns | |||
tLFALL | Low-side driver fall time(1) | CLDRV = 2200 pF, VVDD = 4.5 V,
0.2 V ≤ VSS ≤ 4 V |
48 | ns | ||
tLRISE | Low-side driver rise time(1) | 96 | ns | |||
VOH | High-level output voltage, HDRV
(VBOOST – VHDRV) |
IHDRV = –0.01 A | 0.7 | 1 | V | |
IHDRV = –0.1 A | 0.95 | 1.3 | ||||
VOL | Low-level output voltage, HDRV (VHDRV – VSW) | IHDRV = 0.01A | 0.06 | 0.1 | V | |
IHDRV = 0.1 A | 0.65 | 1 | ||||
VOH | High-level output voltage, LDRV
(VDBP – VLDRV) |
ILDRV= –0.01A | 0.65 | 1 | V | |
ILDRV = –0.1 A | 0.875 | 1.2 | ||||
VOL | Low-level output voltage, LDRV | ILDRV = 0.01 A | 0.03 | 0.05 | V | |
ILDRV = 0.1 A | 0.3 | 0.5 | ||||
VBOOST | Output voltage | VDD = 12 V | 15.2 | 17 | V | |
UVLO | ||||||
VUVLO | Programmable UVLO threshold voltage | RKFF = 90.9 kΩ, turn-on, VVDD rising | 6.2 | 7.2 | 8.2 | V |
Programmable UVLO hysteresis | RKFF = 90.9 kΩ | 1.1 | 1.55 | 2 | V | |
Fixed UVLO threshold voltage | Turn-on, VVDD rising | 4.15 | 4.3 | 4.45 | V | |
Fixed UVLO hysteresis | 275 | 365 | mV | |||
POWER GOOD | ||||||
VPG | Power-good voltage | IPG = 1 mA | 370 | 500 | mV | |
VOH | High-level output voltage, FB | 770 | mV | |||
VOL | Low-level output voltage, FB | 630 | mV | |||
THERMAL SHUTDOWN | ||||||
Shutdown temperature threshold(1) | 165 | °C | ||||
Hysteresis(1) | 15 | °C |