ZHCSNZ3B January 2023 – May 2024 TPS62870 , TPS62871 , TPS62872 , TPS62873
PRODUCTION DATA
- 1
- 1 特性
- 2 应用
- 3 说明
- 4 说明（续）
- 5 Device Options
- 6 Pin Configuration and Functions
- 7 Specifications
-
8 Detailed Description
- 8.1 Overview
- 8.2 Functional Block Diagram
- 8.3
Feature Description
- 8.3.1 Fixed-Frequency DCS Control Topology
- 8.3.2 Forced PWM and Power Save Modes
- 8.3.3 Precise Enable
- 8.3.4 Start-Up
- 8.3.5 Switching Frequency Selection
- 8.3.6 Output Voltage Setting
- 8.3.7 Compensation (COMP)
- 8.3.8 Mode Selection and Clock Synchronization (MODE/SYNC)
- 8.3.9 Spread Spectrum Clocking (SSC)
- 8.3.10 Output Discharge
- 8.3.11 Undervoltage Lockout (UVLO)
- 8.3.12 Overvoltage Lockout (OVLO)
- 8.3.13 Overcurrent Protection
- 8.3.14 Power Good (PG)
- 8.3.15 Remote Sense
- 8.3.16 Thermal Warning and Shutdown
- 8.3.17 Stacked Operation
- 8.4 Device Functional Modes
- 8.5 Programming
- 9 Register Map
- 10Application and Implementation
- 11Device and Documentation Support
- 12Revision History
- 13Mechanical, Packaging, and Orderable Information
8.5.3 I2C Update Sequence
The following are required for a single update:
- A start condition
- A valid I2C address
- A register address byte
- A data byte
After the receipt of each byte, the receiving device acknowledges by pulling the SDA line low during the high period of a single clock pulse. A valid I2C address selects the target. The target performs an update on the falling edge of the acknowledge signal that follows the LSB byte.
Figure 8-19 “Write”
Data Transfer Format in Standard, Fast, Fast Plus Modes
Figure 8-20 “Read”
Data Transfer Format in Standard, Fast, Fast Plus Modes