ZHCSG94L August   2013  – February 2019 TPS659038-Q1 , TPS659039-Q1

PRODUCTION DATA.  

1. 1 器件概要
   1. 1.1 特性
   2. 1.2 应用
   3. 1.3 描述
   4. 1.4 简化方框图
2. 2 修订历史记录
3. 3 Device Comparison
4. 4 Pin Configuration and Functions
   1. 4.1 Pin Functions
      1.      Pin Functions
   2. 4.2 Device Ball Mapping – 13 × 13 nFBGA, 169 Balls, 0,8-mm Pitch
   3. 4.3 Signal Descriptions
5. 5 Specifications
   1. 5.1  Absolute Maximum Ratings
   2. 5.2  ESD Ratings
   3. 5.3  Recommended Operating Conditions
   4. 5.4  Thermal Information
   5. 5.5  Electrical Characteristics: Latch Up Rating
   6. 5.6  Electrical Characteristics: LDO Regulator
   7. 5.7  Electrical Characteristics: Dual-Phase (SMPS12 and SMPS45) and Triple-Phase (SMPS123 and SMPS457) Regulators
   8. 5.8  Electrical Characteristics: Stand-Alone Regulators (SMPS3, SMPS6, SMPS7, SMPS8, and SMPS9)
   9. 5.9  Electrical Characteristics: Reference Generator (Bandgap)
   10. 5.10 Electrical Characteristics: 16-MHz Crystal Oscillator, 32-kHz RC Oscillator, and Output Buffers
   11. 5.11 Electrical Characteristics: DC-DC Clock Sync
   12. 5.12 Electrical Characteristics: 12-Bit Sigma-Delta ADC
   13. 5.13 Electrical Characteristics: Thermal Monitoring and Shutdown
   14. 5.14 Electrical Characteristics: System Control Thresholds
   15. 5.15 Electrical Characteristics: Current Consumption
   16. 5.16 Electrical Characteristics: Digital Input Signal Parameters
   17. 5.17 Electrical Characteristics: Digital Output Signal Parameters
   18. 5.18 Electrical Characteristics: I/O Pullup and Pulldown Resistance
   19. 5.19 I2C Interface Timing Requirements
   20. 5.20 SPI Timing Requirements
   21. 5.21 Typical Characteristics
6. 6 Detailed Description
   1. 6.1 Overview
   2. 6.2 Functional Block Diagrams
   3. 6.3 Feature Description
      1. 6.3.1  Power Management
      2. 6.3.2  Power Resources (Step-Down and Step-Up SMPS Regulators, LDOs)
         1. 6.3.2.1 Step-Down Regulators
            1. 6.3.2.1.1 Sync Clock Functionality
            2. 6.3.2.1.2 Output Voltage and Mode Selection
            3. 6.3.2.1.3 Current Monitoring and Short Circuit Detection
            4. 6.3.2.1.4 POWERGOOD
            5. 6.3.2.1.5 DVS-Capable Regulators
            6. 6.3.2.1.6 Non DVS-Capable Regulators
            7. 6.3.2.1.7 Step-Down Converters SMPS12 and SMPS123
               1.         a. Dual-Phase SMPS and Stand-Alone SMPS
               2.         b. Triple Phase SMPS
            8. 6.3.2.1.8 Step-Down Converter SMPS45 and SMPS457
            9. 6.3.2.1.9 Step-Down Converters SMPS3, SMPS6, SMPS7, SMPS8, and SMPS9
         2. 6.3.2.2 LDOs – Low Dropout Regulators
            1. 6.3.2.2.1 LDOVANA
            2. 6.3.2.2.2 LDOVRTC
            3. 6.3.2.2.3 LDO Bypass (LDO9)
            4. 6.3.2.2.4 LDOUSB
            5. 6.3.2.2.5 Other LDOs
      3. 6.3.3  Long-Press Key Detection
      4. 6.3.4  RTC
         1. 6.3.4.1 General Description
         2. 6.3.4.2 Time Calendar Registers
            1. 6.3.4.2.1 TC Registers Read Access
            2. 6.3.4.2.2 TC Registers Write Access
         3. 6.3.4.3 RTC Alarm
         4. 6.3.4.4 RTC Interrupts
         5. 6.3.4.5 RTC 32-kHz Oscillator Drift Compensation
      5. 6.3.5  GPADC – 12-Bit Sigma-Delta ADC
         1. 6.3.5.1 Asynchronous Conversion Request (SW)
         2. 6.3.5.2 Periodic Conversion Request (AUTO)
         3. 6.3.5.3 Calibration
      6. 6.3.6  General-Purpose I/Os (GPIO Terminals)
         1. 6.3.6.1 REGEN Output
      7. 6.3.7  Thermal Monitoring
         1. 6.3.7.1 Hot-Die Function (HD)
         2. 6.3.7.2 Thermal Shutdown (TS)
         3. 6.3.7.3 Temperature Monitoring With External NTC Resistor or Diode
      8. 6.3.8  Interrupts
      9. 6.3.9  Control Interfaces
         1. 6.3.9.1 I2C Interfaces
            1. 6.3.9.1.1 I2C Implementation
            2. 6.3.9.1.2 F/S Mode Protocol
            3. 6.3.9.1.3 HS Mode Protocol
         2. 6.3.9.2 SPI Interface
            1. 6.3.9.2.1 SPI Modes
            2. 6.3.9.2.2 SPI Protocol
      10. 6.3.10 Device Identification
   4. 6.4 Device Functional Modes
      1. 6.4.1  Embedded Power Controller
      2. 6.4.2  State Transition Requests
         1. 6.4.2.1 ON Requests
         2. 6.4.2.2 OFF Requests
         3. 6.4.2.3 SLEEP and WAKE Requests
      3. 6.4.3  Power Sequences
      4. 6.4.4  Start Up Timing and RESET_OUT Generation
      5. 6.4.5  Power On Acknowledge
         1. 6.4.5.1 POWERHOLD Mode
         2. 6.4.5.2 AUTODEVON Mode
      6. 6.4.6  BOOT Configuration
         1. 6.4.6.1 Boot Terminal Selection
      7. 6.4.7  Reset Levels
      8. 6.4.8  Warm Reset
      9. 6.4.9  RESET_IN
      10. 6.4.10 Watchdog Timer (WDT)
      11. 6.4.11 System Voltage Monitoring
          1. 6.4.11.1 Generating a POR
7. 7 Application and Implementation
   1. 7.1 Application Information
   2. 7.2 Typical Application
      1. 7.2.1 Design Requirements
      2. 7.2.2 Detailed Design Procedure
         1. 7.2.2.1  Recommended External Components
         2. 7.2.2.2  SMPS Input Capacitors
         3. 7.2.2.3  SMPS Output Capacitors
         4. 7.2.2.4  SMPS Inductors
         5. 7.2.2.5  LDO Input Capacitors
         6. 7.2.2.6  LDO Output Capacitors
         7. 7.2.2.7  VCC1
            1. 7.2.2.7.1 Meeting the Power Down Sequence
            2. 7.2.2.7.2 Maintaining Sufficient Input Voltage
         8. 7.2.2.8  VIO_IN
         9. 7.2.2.9  16-MHz Crystal
         10. 7.2.2.10 GPADC
      3. 7.2.3 Application Curves
8. 8 Power Supply Recommendations
9. 9 Layout
   1. 9.1 Layout Guidelines
   2. 9.2 Layout Example
10. 10器件和文档支持
    1. 10.1 器件支持
       1. 10.1.1 第三方米6体育平台手机版_好二三四免责声明
       2. 10.1.2 器件命名规则
    2. 10.2 文档支持
       1. 10.2.1 相关文档
    3. 10.3 相关链接
    4. 10.4 接收文档更新通知
    5. 10.5 社区资源
    6. 10.6 商标
    7. 10.7 静电放电警告
    8. 10.8 Glossary
11. 11机械、封装和可订购信息
    1. 11.1 封装材料信息