The TPS7A83A features a programmable, monotonic, voltage-controlled soft-start that is set with an external capacitor (C_NR/SS).The use of an external C_NR/SS is highly recommended, especially to minimize in-rush current into the output capacitors. This soft-start eliminates power-up initialization problems when powering field-programmable gate arrays (FPGAs), digital signal processors (DSPs), or other processors. The controlled voltage ramp of the output also reduces peak in-rush current during start up, minimizing start-up transients to the input power bus.

To achieve a monotonic start-up, the TPS7A83A error amplifier tracks the voltage ramp of the external soft-start capacitor until the voltage approaches the internal reference. The soft-start ramp time depends on the soft-start charging current (I_NR/SS), the soft-start capacitance (C_NR/SS), and the internal reference (V_NR/SS). Use Equation 6 to calculate the soft-start ramp time:

The noise-reduction capacitor, in conjunction with the noise-reduction resistor, forms a low-pass filter (LPF) that filters out the noise from the reference before being gained up with the error amplifier, thereby reducing the device noise floor. The LPF is a single-pole filter and Equation 7 to calculates the cutoff frequency. The typical value of R_NR/SS is 250 kΩ. Increasing the C_NR/SS capacitor has a greater affect because the output voltage increases when the noise from the reference is gained up even more at higher output voltages. For low-noise applications, a 10-nF to 1-µF C_NR/SS is recommended. When a C_NR/SS capacitor gets larger, the capacitor leakage increases, causing a longer than expected start-up time.