Since the TPS7H500x-SEP uses a transconductance error amplifier (OTA), either Type 2A or Type 2B frequency compensation can be applied. The primary difference between the two compensation schemes is that Type 2A has an additional capacitor C_HF in parallel with R_COMP and C_COMP in order to provide high-frequency noise attenuation. These components will be connected between the COMP pin of the controller, which is the OTA output, and AVSS.

For any of the topologies supported by the TPS7H500x-SEP, the following procedure and equations can be used to select the compensation components. All parameters in the equations are in standard units unless otherwise indicated (that is, H for inductance, F for capacitance, Hz for frequency, and so on).

1. Select the desired crossover frequency (f_c) for the converter.
2. Calculate R_COMP based on the selected crossover frequency f_c.
   Equation 19.

   where:

   • gm_ea is the error amplifier transconductance of 1800 × 10^-6 A/V (typical)
   • V_REF is the 0.613 V reference voltage (typical)
   • gm_PS is the power stage transconductance (see Equation 23)

3. Calculate C_COMP to place compensation zero at the location of the power stage dominant pole.
   Equation 20.
4. Determine the output capacitor ESR zero location (optional).
   Equation 21.
5. Select the capacitor C_HF to provide a high frequency pole to compensate for the ESR zero (optional).
   Equation 22.

For different power converter topologies, the primary change to the compensation selection procedure will be the determination of the power stage transconductance gm_PS. The power stage transconductance can be calculated as shown in Equation 23.

• N_P is the number of primary turns on the main power transformer (set to 1 if no transformer is used)
• N_S is the number of secondary turns on the main power transformer (set to 1 if no transformer is used)
• N_CSP is the number of primary turns on the current sense transformer (set to 1 if no transformer is used)
• N_CSS is the number of secondary turns of the current sense transformer (set to 1 if no transformer is used)
• R_CS is the selected value of the current sense resistor
• CCSR is the ratio to COMP of CS_ILIM

Note that for the TPS7H500x-SEP, the sensed current waveform is compared to the voltage at COMP divided down by the factor CCSR at the PWM comparator, which is accounted for in the denominator of the equation. For buck converters, all turns for the main power transformer can be set equal to 1 and the equation still applies.