The TPS92633 device has single LED short-circuit detection. The single LED short-circuit detection monitors the output voltage when the output current is enabled. Once a single LED short-circuit failure is detected, the device turns off the faulty channel and retries automatically, regardless of the state of the PWM input. If the retry mechanism detects the removal of the single LED short-circuit fault, the device resumes to normal operation.

The TPS92633 monitors the V_(OUTx) voltage of each channel and internally compares the scale down voltage of V_(OUTx) with an external resistor programmable reference voltage on SLS_REF to detect a single LED short-circuit failure. When the voltage of V_(OUTx) falls below V_{(SLS_th_falling)} longer than the deglitch time of t_{(SLS_deg)}, the device asserts the single LED short-circuit fault and pulls low the FAULT pin. During the deglitch time period, if the scale down voltage of V_(OUTx) rises above V_{(SLS_th_rising)}, the timer is reset.

Once the TPS92633 has asserted a single LED short-circuit fault, the device turns off the faulty output channel and retries automatically. During retrying the device sources full current from IN to OUT to pull up the LED loads every 10 ms for 300-µs period when the PWM input is logic high for the faulty channel. Once auto-retry detects the voltage of V_(OUTx) rising above V_{(SLS_th_rising)}, it clears the single LED short-circuit fault and resumes to normal operation. The V_{(SLS_th_rising)} is 2.5% higher the V_{(SLS_th_falling)}. The scale down ratio for V_(OUTx) is N_(OUT). Figure 7-9 describes internal diagram for single LED short-circuit detection circuit. And the V_{(SLS_th_falling)} threshold voltage for single LED short-circuit is calculated by using Equation 6.

Figure 7-9 Single LED Short-Circuit Detection Block Diagram

Equation 6.

where

• V_(IREF) = 1.235 V (typical)
• R_(IREF) = 12.3 kΩ recommended
• R_{(SLS_REF)} is in kΩ unit
• N_(OUT) = 4 (typical)
• N_{(SLS_REF)} = 1 (typical)

The calculated result for V_{(SLS_th_falling)} is 5.34 V when R_(IREF) is 12.3 kΩ and R_{(SLS_REF)} is 13.3 kΩ.

Figure 7-10 illustrates the timing for single-LED short-circuit detection, protection, retry and recovery.

Figure 7-10 Single LED Short-Circuit Detection and Recovery Timing Diagram

The detailed information and value of each time period in Figure 7-10 is described in Timing Requirements.