SCDS261H March 2008 – June 2017 TS5A22364
PRODUCTION DATA.
The TS5A22364 operates from a single 2.3-V to 5.5-V supply. The device must be powered up with a supply voltage on VCC before a voltage can be applied to the signal paths NC and NO. TI recommends to include a 100-μs delay after VCC is at voltage before applying a signal on NC and NO paths
It is also good practice to place a 0.1-μF bypass capacitor on the supply pin VCC to GND to smooth out lower frequency noise to provide better load regulation across the frequency spectrum.