米6体育平台手机版

DLPU110B April 2021 – August 2022 DLPC6540

Programmer's Guide
Trademarks
1 Scope
2 References
3 Acronyms
4 System Boot
1. 4.1 Data In flash
2. 4.2 Bootloader Application
3. 4.3 Main Application
4. 4.4 Commands supported by Bootloader and Main Applications
5. 4.5 Debug Terminal
6. 4.6 HOST_IRQ/SYSTEM_BUSY
7. 4.7 Heartbeat
8. 4.8 Low-level Fault
5 System Status
6 Version
7 Power Modes
8 Display Modes
9 Source Detection and Configuration
10Internal sources
1. 10.1 Test Patterns (TPG)
2. 10.2 Solid Field (SFG) Color
3. 10.3 Curtain
11Display Formatting
12Image Processing
13Illumination Control
14Peripherals
1. 14.1 GPIO
15Interface Protocol
1. 15.1 Supported Interfaces
2. 15.2 I2C Target
3. 15.3 USB
16Command Protocol
1. 16.1 Command Packet
2. 16.2 Response Packet
3. 16.3 Destination Details
4. 16.4 Error Handling and Recovery
5. 16.5 System Busy - I2C scenarios
  1. 16.5.1 GPIO implementation
  2. 16.5.2 Short Status response
6. 16.6 Support for Variable Data Size
17Auto-Initilization Batch File
18Command Descriptions
19 System Commands
1. 19.1 3D
2. 19.2 Administrative
3. 19.3 Autolock
4. 19.4 Blending
5. 19.5 Bootloader
6. 19.6 Calibration
7. 19.7 Debug Internal
8. 19.8 Debug
9. 19.9 General Operation
10. 19.10 Illumination
11. 19.11 Image Processing
12. 19.12 Peripherals
13. 19.13 Warping
14. 19.14 Manual WPC
20Revision History

4.5 Debug Terminal

The application prints several status messages and debug information onto its UART Port0. User has the option to configure that to a different port using DLP Composer tool. The default settings for this UART port is set to 115200 baud rate, 8-bit data, no parity, 1-stop bit and no flow control. These parameters may be changed as per user preference using DLP Composer tool.

The level of messages on the debug terminal is configurable via Set Debug Message Mask command. User may choose to route the debug messages to USB port instead of UART port using Enable USB Debug Log command.