3.1 How to Determine If Your Hardware is Based on eZ-FET or eZ-FET Lite

• Check the installed tool drivers by using the Windows Device Manager. eZ-FET tools enumerate as CDC "MSP Debug Interface" and CDC "MSP Application UART1" devices (see Figure 1).
• Check the Experimenter Board or LaunchPad emulation section to find out if it is based on an eZ-FET tool. If it is based on an MSP430F5528 device, it is an eZ-FET tool.
• There is a small print on the silkscreen that indicates eZ-FET or eZ-FET Lite (see Figure 2 and Figure 5).

Figure 1. eZ-FET Windows Enumeration

Figure 2. eZ-FET Rev 1.2 Emulation IP

Figure 3. eZ-FET Rev 1.4 Emulation IP

Figure 4. eZ-FET Rev 2.0 Emulation IP

Figure 5. eZ-FET Lite Emulation IP