15 |
NP |
R |
0x0 |
Next Page Indication.
0x0 = Link Partner does not desire Next Page Transfer.
0x1 = Link Partner desires Next Page Transfer.
|
14 |
ACK |
R |
0x0 |
Acknowledge.
0x0 = Not acknowledged. The Auto-Negotiation state machine will automatically control the this bit based on the incoming FLP bursts.
0x1 = Link Partner acknowledges reception of the ability data word.
|
13 |
RF |
R |
0x0 |
Remote Fault.
0x0 = No remote fault indicated by link partner.
0x1 = Remote fault indicated by link partner.
|
12 |
RESERVED |
R |
0x0 |
|
11 |
ASMDUP |
R/W |
0x0 |
Asymmetric PAUSE.
0x0 = Asymmetric pause is not supported by the Link Partner.
0x1 = Asymmetric pause is supported by the Link Partner.
|
10 |
PAUSE |
R |
0x0 |
PAUSE.
0x0 = Pause function is not supported by the Link Partner.
0x1 = Pause function is supported by the Link Partner.
|
9 |
100BT4 |
R |
0x0 |
100Base-T4 Support.
0x0 = 100Base-T4 is not supported by the Link Partner.
0x1 = 100Base-T4 is supported by the Link Partner.
|
8 |
100BTXFD |
R |
0x0 |
100Base-TX Full Duplex Support.
0x0 = 100Base-TX Full Duplex is not supported by the Link Partner.
0x1 = 100Base-TX Full Duplex is supported by the Link Partner.
|
7 |
100BTX |
R |
0x0 |
100Base-TX Support.
0x0 = 100Base-TX is not supported by the Link Partner.
0x1 = 100Base-TX is supported by the Link Partner.
|
6 |
10BTFD |
R |
0x0 |
10Base-T Full Duplex Support.
0x0 = 10Base-T Full Duplex is not supported by the Link Partner.
0x1 = 10Base-T Full Duplex is supported by the Link Partner.
|
5 |
10BT |
R |
0x0 |
10Base-T Support.
0x0 = 10Base-T is not supported by the Link Partner.
0x1 = 10Base-T is supported by the Link Partner
|
4-0 |
SELECT |
R |
0x1 |
Protocol Selection. Link Partner's binary encoded protocol selector.
|