15 |
AUTOMDI |
R/W |
0x1 |
Auto-MDIX Enable.
0x0 = Disable Auto- negotiation, Auto-MDIX capability.
0x1 = Enable Auto-negotiation, Auto-MDIX capability.
|
14 |
FORCEMDI |
R/W |
0x0 |
Force MDIX.
0x0 = Normal operation. (Transmit on TPTD pair, Receive on TPRD pair)
0x1 = Force MDI pairs to cross. (Receive on TPTD pair, Transmit on TPRD pair)
|
13 |
PAUSERX |
R |
0x0 |
Pause Receive Negotiated Status.
0x0 = No effect.
0x1 = Indicates that pause receive should be enabled in the MAC.This bit is set based on bits [11:10] in the EPHYANA register and in the EPHYANLPAR register settings.This function is enabled according to IEEE 802.3 Annex 28B Table 28B-3, Pause Resolution, only if the Auto-Negotiated Highest Common Denominator is a full-duplex technology.
|
12 |
PAUSETX |
R |
0x0 |
Pause Transmit Negotiated Status.
0x0 = No effect.
0x1 = Indicates that pause transmit should be enabled in the MAC.This bit is set based on bits [11:10] in the EPHYANA register and in the EPHYANLPAR register settings.This function is enabled according to IEEE 802.3 Annex 28B Table 28B-3, Pause Resolution, only if the Auto-Negotiated Highest Common Denominator is a full-duplex technology.
|
11 |
MIILNKSTAT |
R |
0x0 |
MII Link Status.
0x0 = No active link of 100BT full-duplex has been established using Auto-Negotiation.
0x1 = 100BT Full-duplex Link is active and was established using Auto-Negotiation.
|
10-8 |
RESERVED |
R |
0x0 |
|
7 |
BYPLEDSTRCH |
R/W |
0x0 |
Bypass LED Stretching. This bypasses LED stretching and allows the LEDs to reflect normal operation values.
0x0 = Normal LED operation.
0x1 = Bypass LED stretching.
|
6-0 |
RESERVED |
R |
0x0 |
|