15 |
RESERVED |
R |
0x0 |
|
14 |
ANERR |
R |
0x0 |
Auto-Negotiation Error Interrupt. Reading this bit clears the interrupt.
0x0 = No Auto-negotiation error event pending.
0x1 = Auto-negotiation error interrupt is pending.
|
13 |
PAGERX |
R |
0x0 |
Page Receive Interrupt. Reading this bit clears the interrupt.
0x0 = Page has not been received.
0x1 = Page has been received.
|
12 |
LBFIFO |
R |
0x0 |
Loopback FIFO Overflow/Underflow Event Interrupt. Reading this bit clears the interrupt.
0x0 = No FIFO Overflow/Underflow event pending.
0x1 = FIFO Overflow/Underflow event interrupt pending.
|
11 |
MDICO |
R |
0x0 |
MDI/MDIX Crossover Status Changed Interrupt. Reading this bit clears the interrupt.
0x0 = MDI crossover status has not changed.
0x1 = MDI crossover status changed interrupt is pending.
|
10 |
SLEEP |
R |
0x0 |
Sleep Mode Event Interrupt. Reading this bit clears the interrupt.
0x0 = No sleep mode event pending.
0x1 = Sleep Mode event interrupt is pending.
|
9 |
POLINT |
R |
0x0 |
Polarity Changed Interrupt. Reading this bit clears the interrupt.
0x0 = No Data polarity event pending.
0x1 = Data polarity changed interrupt pending.
|
8 |
JABBER |
R |
0x0 |
Jabber Detect Event Interrupt. Reading this bit clears the interrupt.
0x0 = No Jabber detect event pending
0x1 = Jabber detect event interrupt pending.
|
7 |
RESERVED |
R |
0x0 |
|
6 |
ANERREN |
R/W |
0x0 |
Auto-Negotiation Error Interrupt Enable.
0x0 = Auto-Negotiation error event interrupt disabled.
0x1 = Enable interrupt on Auto-Negotiation error event
|
5 |
PAGERXEN |
R/W |
0x0 |
Page Receive Interrupt Enable.
0x0 = Page Receive error event interrupt disabled.
0x1 = Page receive event interrupt enabled.
|
4 |
LBFIFOEN |
R/W |
0x0 |
Loopback FIFO Overflow/Underflow Interrupt Enable.
0x0 = Loopback FIFO overflow/underflow event interrupt disabled
0x1 = Loopback FIFO overflow/underflow event interrupt enabled.
|
3 |
MDICOEN |
R/W |
0x0 |
MDI/MDIX Crossover Status Changed Interrupt Enable.
0x0 = MDI/MDIX Crossover Change Status interrupt disabled
0x1 = MDI/MDIX Crossover Change Status interrupt enabled.
|
2 |
SLEEPEN |
R/W |
0x0 |
Sleep Mode Event Interrupt Enable.
0x0 = Sleep mode interrupt disabled.
0x1 = Sleep Mode event interrupt enabled.
|
1 |
POLINTEN |
R/W |
0x0 |
Polarity Changed Interrupt Enable.
0x0 = Polarity Change interrupt is disabled.
0x1 = Polarity change interrupt is enabled.
|
0 |
JABBEREN |
R |
0x0 |
Jabber Detect Event Interrupt Enable.
0x0 = Jabber detect interrupt disabled.
0x1 = Jabber detect interrupt enabled.
|