SLAU723A October 2017 – October 2018 MSP432E401Y , MSP432E411Y
Controller Area Network Peripheral Ready (PRCAN)
The PRCAN register indicates whether the CAN modules are ready to be accessed by software following a change in status of power, run mode clocking, or reset. A power change is initiated if the corresponding PCCAN bit is changed from 0 to 1. A run mode clocking change is initiated if the corresponding RCGCCAN bit is changed. A reset change is initiated if the corresponding SRCAN bit is changed from 0 to 1.
The PRCAN bit is cleared on any of the preceding events and is not set again until the module is completely powered, enabled, and internally reset.
PRCAN is shown in Figure 4-186 and described in Table 4-214.
Return to Summary Table.
31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
RESERVED | |||||||||||||||
R-0x0 | |||||||||||||||
15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
RESERVED | R1 | R0 | |||||||||||||
R-0x0 | R-0x0 | R-0x0 | |||||||||||||