SLAU723A October 2017 – October 2018 MSP432E401Y , MSP432E411Y
Watchdog Timer Peripheral Ready (PRWD)
The PRWD register indicates whether the watchdog modules are ready to be accessed by software following a change in status of power, run mode clocking, or reset. A power change is initiated if the corresponding PCWD bit is changed from 0 to 1. A run mode clocking change is initiated if the corresponding RCGCWD bit is changed. A reset change is initiated if the corresponding SRWD bit is changed from 0 to 1.
The PRWD bit is cleared on any of the preceding events and is not set again until the module is completely powered, enabled, and internally reset.
PRWD is shown in Figure 4-175 and described in Table 4-203.
Return to Summary Table.
31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 |
RESERVED | |||||||||||||||
R-0x0 | |||||||||||||||
15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
RESERVED | R1 | R0 | |||||||||||||
R-0x0 | R-0x0 | R-0x0 | |||||||||||||