SLDU028A January   2018  – March 2020 TPS65313-Q1

 

  1.   TPS65313-EVM User’s Guide
    1.     Trademarks
    2. TPS65313-EVM Top View With Basic External Connections
    3. TPS65313-EVM Input, Output Voltages, and Load Current Requirements
    4. TPS65313-EVM Jumper Settings
    5. TPS65313-EVM GUI Installing and Opening the GUI
    6. TPS65313-EVM Power-Up and Power-Down Procedure
    7. TPS65313 GUI
      1. 6.1 Device Controls Page
        1. 6.1.1 Re-Initialize USB2ANY Button
        2. 6.1.2 WAKE Button
        3. 6.1.3 Power Off Button
        4. 6.1.4 Device Status Update
        5. 6.1.5 State Transitions
        6. 6.1.6 Enable Q&A Watchdog
        7. 6.1.7 MCU Error Signal Monitor (ESM)
        8. 6.1.8 SPI Status Bits
        9. 6.1.9 Moniter ENDRV and NRES Button
      2. 6.2 Register Map Page
      3. 6.3 EEPROM Programming Page
    8. TPS65313-EVM Typical Plots
      1. 7.1 Efficiency Plots
      2. 7.2 Power-Up Plots
      3. 7.3 Power-Down Plots
      4. 7.4 Ripple Voltage Plots
      5. 7.5 Load Transient Plots
      6. 7.6 Stability Measurements
    9. TPS65313-EVM Schematic Diagram
    10. TPS65313-EVM Part List
    11. 10 PCB Layer Diagram
    12. 11 Description of the Watchdog Algorithm Implemented on EVM
  2.   Revision History

Efficiency Plots

tps65313Q1e1_buck1_efficiency_plot.gif

The total current in to the VIN, AVIN, and VIN_SAFE pins was considered for this plot with the EXTSUP supply connected to the BOOST converter.
Figure 9. BUCK1 Efficiency Plot for VIN = 13 V

tps65313Q1e1_boost_efficiency_plot.gifFigure 11. BOOST Efficiency Plot

tps65313Q1e1_buck2_efficiency_plot.gif

Figure 10. BUCK2 Efficiency Plot