SLLU312A July 2019 – May 2022 TCAN4550-Q1
The TCAN4550-Q1 has several operating modes: Normal, Standby and Sleep modes, as well as two protected modes. The first three mode selections are made by the writing to SPI register. The two protected modes are modified Standby modes used to protect the device or bus and are entered from a fault condition only. The TCAN4550-Q1 automatically goes from Sleep to Standby mode when receiving a WUP or LWU event. See Table 3-3 for the various modes and what parts of the device are active during the each mode.
The TCAN4550-Q1 state diagram figure, see Figure 3-6, shows the biasing of the CAN bus in each of the modes of operation.
Mode | RST Pin | nINT | nWKRQ | INH | GPO2 | Low Power CAN RX | WAKE Pin | WD | SPI | GPIO1 | OSC | CAN TX/ RX | VCCOUT | Memory & Configuration |
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Normal | L | On | On | On | On | Off | Off | On | On | On | On | On | On | Saved |
Standby | L | On | On | On | On | On | On | On | On | On | On | Off | On | Saved |
TSD Protected | L | On | On | On | On | On | On | On | On | On | On | Off | Off | Saved |
UVIO Protected | L | Off | On | Off | Off | On | On | Off | Off | Off | Off | Mode Dependent | On | Saved |
Sleep | L | Off | On | Off | Off | On | On | Off | Off | Off | Off | Off | Off | Partially Saved |