at TA = 25°C,
VCC = ±15 V, gain = +10 V/V, RL = 150 Ω, and RF
= 220 Ω (unless otherwise noted)
| VCC = ±15 V, VOUT = 100
mVPP |
Figure 5-1 Frequency Response vs
Feedback Resistance
| VCC = ±15 V, VOUT = 100
mVPP |
Figure 5-3 Frequency Response vs
Gain
Figure 5-5 Large-Signal Frequency
Response
Figure 5-7 Closed-Loop Output
Impedance
Figure 5-9 Power-Supply Rejection
Ratio vs Frequency
Figure 5-11 Input-Referred Voltage
Noise vs Frequency
| VCC = ±15 V, RL = 1 kΩ,
VOUT = 2 VPP |
Figure 5-13 Harmonic Distortion vs Frequency
| VCC = ±15 V, RL = 150 Ω,
VOUT = 2 VPP |
Figure 5-15 Harmonic Distortion vs Frequency
| VCC = ±15 V, RL = 1 kΩ, f = 1
MHz |
Figure 5-17 Harmonic Distortion vs
Peak‑to‑Peak Output Voltage
| VCC = ±15 V, VOUT = 2
VPP |
Figure 5-19 Total Harmonic Distortion
vs Frequency
Figure 5-21 1-V Step Response
Figure 5-23 10-V Step Response
Figure 5-25 Voltage Offset
Distribution
Figure 5-27 Input Offset Current vs
Ambient Temperature
Figure 5-29 Maximum Output Voltage
Swing vs Ambient Temperature
Figure 5-31 Supply Current vs
Ambient Temperature
| VCC = ±5 V, VOUT = 100
mVPP |
Figure 5-2 Frequency Response vs
Feedback Resistance
| VCC = ±5 V, VOUT = 100
mVPP |
Figure 5-4 Frequency Response vs
Gain
Figure 5-6 Large-Signal Frequency
Response
Figure 5-8 Open-loop Gain and Phase
Response
Figure 5-10 Common-Mode Rejection
Ratio vs Frequency
| VCC = ±15 V, RL = 150 Ω,
VOUT = 2 VPP |
Figure 5-12 Input-Referred Current
Noise vs Frequency
| VCC = ±5 V, RL = 1 kΩ,
VOUT = 2 VPP |
Figure 5-14 Harmonic Distortion vs Frequency
| VCC = ±5 V, RL = 150 Ω,
VOUT = 2 VPP |
Figure 5-16 Harmonic Distortion vs Frequency
| VCC = ±15 V, RL = 150 Ω, f =
1 MHz |
Figure 5-18 Harmonic Distortion vs
Peak‑to‑Peak Output Voltage
Figure 5-20 Crosstalk vs Frequency
Figure 5-22 5-V Step Response
Figure 5-24 Input Offset Voltage vs
Ambient Temperature
Figure 5-26 Input Offset Current vs
Ambient Temperature
Figure 5-28 Offset Voltage vs Output
Voltage
Figure 5-30 Output Swing vs Load
Current