The DRV2625EVM-CT firmware contains haptic waveforms which showcase the features and benefits of the DRV2625. Follow the instructions below to begin the demo:

1. Out of the box, the jumpers are set to begin demo mode using USB power. The default jumper settings are found in the table below.
   Table 1-2 Jumper Descriptions

   Jumper	Default Position	Description
   J3	Short pin 2-3	Powers using USB
   J2	Short pin 2-3	USB power to DVDD
   J5	Shorted	Level translator
   J17	Open	Trigger/NRST for DRV2625
   J7	Shorted	Bypass the I-Sense
   J8	Shorted	Motor+ terminal
   J9	Shorted	Motor- terminal
   J4	Open	SDA/SCL connections to debug/Monitor advanced operations

2. Connect the included micro-USB cable to the USB connector on the DRV2625EVM-CT board.
3. Connect the other end of the USB cable to an available USB port on a computer, USB charger, or USB battery pack.
4. If the board is powered correctly, the LEDs will blink and the LRA and the ERM actuator will spin and stop at the start up.