米6体育平台手机版

SLOU432B December 2015 – December 2021 DRV2625

1 Getting Started
1. 1.1 Evaluation Module Operating Parameters
2. 1.2 Quick Start Board Setup
2 DRV2625 Demonstration Program
3 Additional Hardware Modes
4 Hardware Configuration
5 Measurement and Analysis
1. 5.1 Using Low-Pass Filter to Record Waveforms
6 Modifying or Reprogramming the Firmware
1. 6.1 MSP430 Pin-Out
7 Schematic
8 Layout
9 Bill of Materials
10Revision History
11Trademarks

4.1 Input and Output Overview

The DRV2625EVM-CT allows complete evaluation of the DRV2625 though test points, jacks, and connectors. Table 4-1 gives a brief description of the hardware.

Table 4-1 Hardware Overview

Signal	Description	I/O
DRV TRIG	External input or monitor for DRV2625 IN/TRIG pin	Input/Output
NRST	External DRV2625 Shutdown control	Input
OUT+/OUT–	Filtered output test points for observation, connect to oscilloscope or measurement equipment	Output
USB	USB power (5 V)	Input
VBAT	External Supply Power (2.5 V – 5.5 V)	Input
SBW	MSP430 programming header	Input/Output
I²C	DRV2625 and MSP430 I²C bus	Input/Output

Hardware configuration details can be found in the following sections.