SLUA888 May 2018 TPS53622 , TPS53659 , TPS53679 , TPS53681
-
NVM Programming for VR13 Power Controllers
- Trademarks
- 1 Introduction
- 2 Technical Overview
- 3
Use of TI Programming Tools
- 3.1
Fusion Digital Power Designer
- 3.1.1 Build and Export a System (.tifsp) File
- 3.1.2 View a Project File or System File Offline
- 3.1.3 Import a Project File to a Single Online Device
- 3.1.4 Import a System File to an Online System
- 3.1.5 Export CSV Script for Third Party Tools
- 3.1.6 Compare Two Project Files
- 3.1.7 Build a System File from Existing Project Files
- 3.2 Fusion Manufacturing Tool
- 3.3 TI Programming Board
- 3.1
Fusion Digital Power Designer
3.1.5 Export CSV Script for Third Party Tools
The Fusion Digital Power Designer software also exports configuration data to a comma-separated text file (.csv). Third-party software or programming vendors usually require the .csv format because it is easy to adapt to existing software.
- To export data from a single device, click Click to Configure Device from the System View.
- From the File menu, select Export...
- From the Device Export page, click PMBus Programmer Script tab.
- Use the settings shown in Figure 29 for most situations. Third-party software sometimes has other requirements.
- After you complete the settings, click Export PMBus Programmer Script .
- The system generates a text file, and saves it to the path you select as the output folder.
Figure 28. Device File Export
Figure 29. Recommended CSV Export Settings