米6体育平台手机版

SLUUC44A July 2019 – December 2022 TPSM82810 , TPSM82813 , TPSM82816

TPSM8281xEVM-089 Evaluation Module
Trademarks
1Introduction
1. 1.1 Performance Specification
2. 1.2 Modifications
2Setup
1. 2.1 Hardware Setup
2. 2.2 Input, Output Connector, and Jumper Descriptions
3Safety Instructions
4TPSM8281xEVM-089 Test Results
5Board Layout
6Schematic and Bill of Materials
1. 6.1 Schematic
2. 6.2 Bill of Materials
A Appendix - Rev.A EVM
1. A.1 Rev.A - Setup
  1. A.1.1 Rev.A - Connector Descriptions
  2. A.1.2 Rev.A - Hardware Setup
2. A.2 Rev.A - Board Layout
3. A.3 Rev.A - Schematic and Bill of Materials
  1. A.3.1 Rev.A - Schematic
  2. A.3.2 Rev.A - Bill of Materials
B Revision History

2.1 Hardware Setup

To operate the EVM, set jumpers JP1 and JP2 to the desired positions per Input, Output Connector and Jumper Descriptions. Connect the input supply to J1, between VIN and GND, and connect the load to J2 between VOUT and GND.