米6体育平台手机版

SLUUC44A July 2019 – December 2022 TPSM82810 , TPSM82813 , TPSM82816

TPSM8281xEVM-089 Evaluation Module
Trademarks
1Introduction
1. 1.1 Performance Specification
2. 1.2 Modifications
2Setup
1. 2.1 Hardware Setup
2. 2.2 Input, Output Connector, and Jumper Descriptions
3Safety Instructions
4TPSM8281xEVM-089 Test Results
5Board Layout
6Schematic and Bill of Materials
1. 6.1 Schematic
2. 6.2 Bill of Materials
A Appendix - Rev.A EVM
1. A.1 Rev.A - Setup
  1. A.1.1 Rev.A - Connector Descriptions
  2. A.1.2 Rev.A - Hardware Setup
2. A.2 Rev.A - Board Layout
3. A.3 Rev.A - Schematic and Bill of Materials
  1. A.3.1 Rev.A - Schematic
  2. A.3.2 Rev.A - Bill of Materials
B Revision History

1.2 Modifications

The printed-circuit board (PCB) for this EVM is designed to accommodate some modifications by the user. Additional input and output capacitors can be added. Also, the switching frequency, spread spectrum, control loop compensation, and soft-start time can be changed. Finally, the loop response can be measured and a precise turn-on voltage can be implemented.