If the user does not have access to a high voltage lab and proper high voltage lab equipment, then using a 40-V supply and the EVM's 40-V network to provide voltage to the various parameters the user wishes to measure is a possibility. To utilize this 40-V supply option, connect a 40-V power supply to the VCC40V connector located near the bottom of the board. To use this feature, the user must also populate jumpers J7, J8, J29, J1, J30, and J2 with shunts to connect VCC40V to the desired network. The blue regions in the figure above show the jumpers that must be populated to connect each network to the VCC40V supply.