SLUUCC4A October 2020 – September 2021 TPS92520-Q1
- Trademarks
- General Texas Instruments High Voltage Evaluation (TI HV EMV) User Safety Guidelines
- 1Description
- 2Performance Specifications
- 3Performance Data and Typical Characteristic Curves
- 4Schematic, PCB Layout, and Bill of Materials
- 5Software
- 6TPS92520EVM-133 Power Up and Operation
- 7Revision History
5.3 Installation Error Recovery
If the screen shown in Figure 5-19 appears, use the following steps to install an unsigned driver one time.
- Click Start and select Settings
- Click Update and Security
- Click Recovery
- Click Restart Now under Advanced Startup
- Click Troubleshoot
- Select Advanced Options
- Select Startup Settings
- Click Restart
- On the Startup Settings screen, press F7 during reboot to disable driver signature enforcement. The host computer restarts.
- Repeat the entire re-installation process
- A message appears informing that installing .NET failed. Close that window and continue.
- Double-click Install unsigned drivers
After restarting a second time, the host computer resets. The reset requires all drivers to be digitally signed the next time a default installation executes, unless these steps are repeated.
Figure 5-19 Setup Screen 19