Voltage Source: The input voltage source V_IN must be a 36-V variable DC source capable of supplying 6 A.

Multimeters:

• Voltmeter 1: Measure the input voltage at VIN S+ to VIN S–.
• Voltmeter 2: Measure the output voltage at VOUT S+ to VOUT S–.
• Ammeter 1: Measure the input current. Set the ammeter to 1-second aperture time.
• Ammeter 2: Measure the output current. Set the ammeter to 1-second aperture time.

Electronic Load: Use an electronic load set to constant-resistance (CR) or constant-current (CC) mode and capable of 0 ADC to 6 ADC. For a no-load input current measurement, disconnect the electronic load as it can draw a small residual current.

Oscilloscope: With the scope set to 20-MHz bandwidth and AC coupling, measure the output voltage ripple directly across an output capacitor with a short ground lead normally provided with the scope probe. Place the oscilloscope probe tip on the positive terminal of the output capacitor, holding the ground barrel of the probe through the ground lead to the negative terminal of the capacitor. TI does not recommend using a long-leaded ground connection because this may induce additional noise given a large ground loop. To measure other waveforms, adjust the oscilloscope as needed.

Safety: Always use caution when touching any circuits that can be live or energized.