5 Test Setup and Procedures

In this user's guide section, the test procedure is described for TPS25961EVM testing.

Make sure the evaluation board has default jumper settings as shown in Table 5-1.

Table 5-1 Default Jumper Setting for TPS25961EVM eFuse Evaluation Board

J2	J3	J4
Open	5-6	1-2

Figure 5-1 TPS25961EVM Setup with Test Equipment

Follow these instructions before starting any test and repeat again before moving to the next test:

Set the power supply output (VIN) to zero volts.
Turn ON the power supply and set the power supply output (VIN) to 12 V, current limit = 2 A.
Turn OFF the power supply.
Set the jumper setting on EVM to default position as shown in Table 5-1.