SNOK005 October   2024 LMP7704-SP

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Overview
  5. 2Test Procedures
  6. 3Facility
  7. 4Results
    1. 4.1 Input Offset Voltage Parametric Shift
  8. 5Summary of Results
  9.   A Test Results

Test Procedures

The LMP7704-SP samples were electrically pre-tested using the production automated test equipment program. General test procedures were per MIL-STD-883, Method 1017. The exposed devices were then re-tested on the same ATE hardware. An additional control unit (serial number 13) that was not exposed to the neutron source was measured alongside the exposed samples, for both pre- and post-exposure ATE testing. The specified limits at TA = 25°C are listed below.

Table 2-1 LMP7704-SP Specification Compliance Matrix
Parameter Test Condition LMP7704-SP Data Sheet (SNOSDB6) Test #
MIN TYP MAX Unit

Input offset voltage

±60

±260

µV

104.4 to 104.11

Power-supply rejection ratio

2.7V < VS < 12V

86

100

dB

104.16 to 104.19

2.7V < VS < 12V, Flight model post-HDR exposure

82

Input bias current

VS = 5V

±0.5

±10

pA

120.0–120.3

VS = 5V, Flight model post-TID exposure ±400

VS = 10V

±1

±10

pA

120.12 to 120.15

VS = 10V, Flight model post-TID exposure

±400

Input offset current

±40

fA

120.8 to 120.11, 120.20 to 120.23

Common-mode rejection ratio

VS = 5V, (V–) < VCM < (V+)

85

130

dB

105.0 to 105.3

VS = 5V, (V–) < VCM < (V+), Flight model post-HDR exposure

76

VS = 10V, (V–) < VCM < (V+)

90

130

dB

105.4 to 105.7

VS = 10V, (V–) < VCM < (V+), Flight model post-HDR exposure

83

Open-loop voltage gain

VS = 5V, (V–) + 0.3V < VOUT < (V+) – 0.3V, RL = 2kΩ

100

119

dB

106.0 to 106.3

VS = 5V, (V–) + 0.3V < VOUT < (V+) – 0.3V, RL = 2kΩ, Flight model post-HDR exposure

84

VS = 5V, (V–) + 0.2V < VOUT < (V+) – 0.2V, RL = 10kΩ

100

130

dB

106.4 to 106.7

VS = 10V, (V–) + 0.3V < VOUT < (V+) – 0.3V, RL = 2kΩ

100

121

dB

106.8 to 106.11

VS = 10V, (V–) + 0.2V < VOUT < (V+) – 0.2V, RL = 10kΩ

100

134

dB

106.12 to 106.15

Gain bandwidth

2.5

MHz

116.x

Slew rate

VS = 10V, G = 1, 9V step, 10% to 90% rising

0.8

V/µs

109.x

Voltage output swing from rail

Positive rail, RL = 2kΩ to VS / 2

60

120

mV

110.0 to 110.3, 110.16 to 110.19

Positive rail, RL = 10kΩ to VS / 2

40

60

110.8 to 110.11, 110.24 to 110.27

Negative rail, RL = 2kΩ to VS / 2

50

120

mV

110.4 to 110.7, 110.20 to 110.23

Negative rail, RL = 10kΩ to VS / 2

30

50

110.12 to 110.15, 110.28 to 110.31

Short-circuit current

VS = 5V, VOUT = VS / 2, VIN = ±100mV

+66, –76

mA

111.x

Total quiescent current

VS = 5V, IO = 0A

2.9

3.7

mA

101.2, 101.3, 112.2, 112.3

VS = 10V, IO = 0A

3.2

4.2

mA

101.4, 101.5, 112.4, 112.5

Table 2-2 Neutron Irradiation Conditions
Serial Numbers Sample Qty Neutron Fluence (n/cm2) Bias
1, 2, 3, 4 4 1.0 × 1012 Unbiased
5, 6, 7, 8 4 5.0 × 1012 Unbiased
9, 10, 11, 12 4 1.0 × 1013 Unbiased