SNOU173A October   2020  – December 2020 LM7310

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 EVM Features
    2. 1.2 EVM Applications
  3. 2Description
  4. 3Schematic
  5. 4General Configurations
    1. 4.1 Physical Access
    2. 4.2 Test Equipment and Set up
      1. 4.2.1 POWER SUPPLIES
      2. 4.2.2 METERS
      3. 4.2.3 OSCILLOSCOPE
      4. 4.2.4 LOADS
  6. 5Test Setup and Procedures
    1. 5.1 Startup Test
    2. 5.2 ORing of Two Power Supplies Test
    3. 5.3 Reverse Current Blocking Test
    4. 5.4 Output Short-Circuit Test
    5. 5.5 Input Reverse Polarity Test
  7. 6EVAL Board Assembly Drawings and Layout Guidelines
    1. 6.1 PCB Drawings
  8. 7Bill Of Materials (BoM)
  9. 8Revision History

PCB Drawings

Figure 6-1 and Figure 6-2 show component placement of the evaluation board. Figure 6-3 and Figure 6-4 show the PCB layout images.

GUID-20200922-CA0I-XVKJ-RJBK-WKRK4RGRPJNG-low.gifFigure 6-1 LM73100EVM Board Top Assembly.
GUID-20200922-CA0I-PKJD-38SN-9VNS3SC5TCFJ-low.gifFigure 6-3 LM73100EVM Board Top Layer.
GUID-20200922-CA0I-RPNK-W6XR-HV4MZ1FNRRGQ-low.gifFigure 6-2 LM73100EVM Board Bottom Assembly.
GUID-20200922-CA0I-CTQ6-PT1S-RK0M5HGFRLZN-low.gifFigure 6-4 LM73100EVM Board Bottom Layer.